Huawei RH2288 V3 User Manual page 283

RH2288 V3 Server
User Guide
Logging In over Telnet
Step 1 Connect the local PC to the iBMC management network port on the server by using a network
cable. Ensure that the IP addresses of the local PC and the iBMC management network port
are on the same network segment.
Step 2 Check that the Telnet service is enabled.
Step 3 Run the following command in the terminal tool to log in to the iBMC CLI:.
telnet iBMC IP address
----End
Logging In over the Serial Port
Step 1 Set the serial port as the iBMC serial port.
You can set the serial port through the iBMC CLI or by using a jumper of the server.
l
l
Issue 32 (2019-03-28)
NOTE
l iBMC 2.20 and later versions do not support CLI login over Telnet.
l Telnet poses security risks and is disabled by default.
To set the serial port through the iBMC CLI, do as follows:
a. Log in to the iBMC CLI over SSH or Telnet.
NOTE
iBMC 2.20 and later versions do not support CLI login over Telnet.
b. Run the following command to change the serial port direction:
ipmcset -d serialdir -v <option>
Param Description
eter
<optio Serial port direction
n>
To set the serial port by using a jumper, do as follows:
Copyright © Huawei Technologies Co., Ltd.
Value
The value options of this parameter and the
value meanings vary according to the server
model. Run the ipmcget -d serialdir command
to view the value options.
For a rack server, the options are as follows:
0: switch from PANEL COM to SYS COM
n
1: switch from PANEL COM to iBMC
n
COM
2: switch from SOL COM to SYS COM
n
3: switch from SOL COM to iBMC COM
n
4: switch from SYS COM to iBMC COM
n
To set the panel serial port as the iBMC serial
port, run the ipmcset -d serialdir -v 1
command.
9 Common Operations
271