RH2288 V3 Server
User Guide
13
15
17
19
21
23
25
27
29
31
2.7 Internal Cabling
This section describes the internal cabling for an RH2288 V3 with different configurations.
2.7.1 Internal Cabling for an M.2 SSD Riser Card
Internal Cabling for an M.2 SSD Riser Card on a Server with a DVD Drive
For an RH2288 V3 with a DVD drive, an M.2 SSD riser card can be configured with only one
M.2 SATA SSD card, which uses the external SATA2 port.
Issue 32 (2019-03-28)
Jumper (J36)
NOTE
COM_SW pins are used for changing the
serial port direction, and CLR_BMC_PW pins
are used for restoring the default iBMC
settings.
Fan 4 connector (J130)
Fan 3 connector (J131)
Fan 1 connector (J133)
Hard disk backplane power connector
(J30 PWR CONN1)
Left mounting ear connector (J42)
SATA/SATADOM 2 (J38)
Rear disk backplane power connector 2
(J29 PWR CONN3)
System battery
Riser card connector (corresponding to
CPU 2, J3-J1005)
NOTE
This section uses a RAID controller card on the mainboard as an example to describe how to connect
cables to the card. The method for connecting cables to a standard RAID controller card is the same as
that for connecting cables to a RAID controller card on the mainboard.
NOTE
An M.2 SSD riser card can be installed only in a PCIe slot on the mainboard or a riser card.
Copyright © Huawei Technologies Co., Ltd.
14
RAID controller card (J44)
16
Right mounting ear connector
(J43)
18
Fan 2 connector (J132)
20
Onboard USB 3.0 connector (J53)
22
Hard disk backplane signal
connector (J1003)
24
SATA/SATADOM 1 (J37)
26
PSU backplane connector (J31)
28
SoftRAID key (J51)
30
Dual-SD module (SD BOARD)
-
-
2 Overview
34