Huawei RH2288 V3 User Manual page 33

RH2288 V3 Server
User Guide
Indicator
UID indicator
PSU indicator
Hard disk activity indicator
Hard disk fault indicator
Table 2-8
panel.
Issue 32 (2019-03-28)
describes the indicators of LANs on motherboard (LOMs) on the RH2288 V3 rear
Copyright © Huawei Technologies Co., Ltd.
State
l Off: The server is not located.
l Steady blue: The server is located.
750 W AC Platinum PSU
l Off: There is no AC power input; the input
overvoltage or undervoltage occurs and the
PSU is not detected; the PSU is abnormal.
l Steady green: Both the active output and the
standby output are normal.
750 W AC Titanium PSU
l Off: There is no power supply to the PSU.
l Blinking green at 1 Hz:
– The input is normal, but the PSU stops the
output due to PSON or Present#.
– The input is overvoltage or undervoltage.
l Steady orange: The input is normal, but no
output is supplied due to overheat protection,
overcurrent protection, short circuit protection,
output overvoltage protection, or some
component failures.
l Steady green: Both the active output and the
standby output are normal.
l Off: The hard disk is not detected or is faulty.
l Blinking green: Data is being read from or
written to the hard disk, or synchronized
between hard disks.
l Steady green: The hard disk is inactive.
l Off: The hard disk is working properly.
l Blinking yellow: The hard disk is located, or
rebuilding RAID.
l Steady yellow: The hard disk is faulty, or hard
disk members of the RAID array the hard disk
is in are abnormal.
NOTE
If the fault indicator is steady yellow, run related
commands to check the RAID status to determine
whether the RAID array status is abnormal or whether
the hard disk is faulty. For details about command
description, see Huawei V2&V3 Server RAID
Controller Card User Guide.
2 Overview
21