Removing A Dimm - Huawei RH2288 V3 User Manual

RH2288 V3 Server
User Guide
Figure 7-85 Installing a heat sink
Step 11 Use a Phillips screwdriver to tighten one pair of diagonally opposite screws on the heat sink
halfway and then tighten the other pair of screws. See step (2) in
Step 12 Install the air duct. For details, see
Step 13 Install full-height full-length riser cards if they are required. For details, see
Riser
Step 14 Install the chassis cover. For details, see
Step 15 Install the RH2288 V3. For details, see
Step 16 Connect all external cables such as power and network cables. For details, see
Connecting External
Step 17 Power on the RH2288 V3. For details, see
----End

7.39 Removing a DIMM

Remove a DIMM if it has failed or needs to be replaced with a new model.
Procedure
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Determine the cabinet number and chassis number of the server, and label its panel to prevent
misoperations.
Step 3 Power off the RH2288 V3. For details, see
Issue 32 (2019-03-28)
Card.
Cables.
Copyright © Huawei Technologies Co., Ltd.
7.14 Installing the Air
7.12 Installing the Chassis
3.4 Installing the
4.1 Powering On the
1 Safety Instructions.
4.2 Powering Off the
7 Replacing Parts
Figure 7-85.
Duct.
7.20 Installing a
Cover.
Server.
3.5
Server.
Server.
204