Table of Contents
Advertisement
F(L)CS Data Acquisition
3. Start the FCS Wizard by selecting the FCS operating mode (Figure 153). Using FCS is
logical only if the software has not been started previously in resonant mode (Resonant
Scanner).
Figure 153:
4. Select the Setup Imaging step (Figure 154, item 1).
Figure 154:
5. Click the Workflow tab (Figure 154, item 2).
6. Focus on the bleach specimen.
178
Opening the FCS Wizard in LAS AF
Calling up the procedure for calibrating the FCS measurement position in the FCS Wizard
Advertisement
Table of Contents
