F(L)CS Data Acquisition
Figure 158:
7. Switch the APDs off electrically.
8. Select the initial bleach point in the xy image by clicking a point in the image display
(Figure 158). Click the Add button (Figure 159, item 1).
Figure 159:
9. Select the next bleach point and click the Add button again. Continue until you have
marked all the points you want.
10. Set the number of cycles to 1 by enabling the Image after each _ cycle check box in the
182
Testing the accuracy of the FCS measuring points – Setting the bleach points
Adding a bleach point and bleaching period