Table of Contents
Advertisement
Switching Off the System
3. Save all relevant data in SymPhoTime and close the SymPhoTime software.
4. Turn off the lasers in the supply unit with the key switch on the main switch board of the
flexible supply unit (see Figure 200, item 4).
Figure 200:
The emission warning indicator goes out.
5. If you are using a DSN-102 power supply, switch off the detectors by pressing the
channel buttons on DSN 102.
6. If you are using the PDL 828 Sepia II laser driver, set the key switch to the "OFF" position.
7. If your system has a white light laser, check whether the emission warning indicator
lights. Should the emission warning indicator on the front side of the white light laser be
lit, press the key below it. This causes all internal white light laser components to shut
off and the emission warning indicator to go out.
Figure 201:
8. Switch off the white light laser with the detachable-key switch on the front of the white
light laser.
230
Overview of the main switch board on the flexible supply unit
Emission Warning Indicator on the White Light Laser
Advertisement
Table of Contents
