Related Manuals for Leica HI1220
Summary of Contents for Leica HI1220
- Page 1 Instructions for Use Leica HI1220 Flattening Table Leica HI1220 V 3.3 , English 07/2016 Order No.: 14 0423 80101 RevG Always keep this manual with the instrument. Read carefully before working with the instrument.
- Page 3 Leica reserves the right to change technical following thorough investigation in this field. specifications as well as manufacturing process- We are under no obligation to update the pres- es without prior notice.
-
Page 4: Table Of Contents
Technical data ..........................9 Instrument Setup ......................10 Installation site requirements ....................10 Standard delivery ........................10 Unpacking and setting up the HI1220 ..................11 Setting up the power supply ..................... 11 Operation ........................12 Control panel fields on the instrument ..................12 Switching the instrument on ..................... -
Page 5: Important Information
European directives. Minimum 10 % r.H., Maximum 85 % r.H Caution, consult the instructions for Indicates the item can be recycled use for cautionary information. where correct facilities exist. Leica HI1220 Flattening Table... -
Page 6: Qualification Of Personnel
EMC and EME. ber is attached to the rear side of the instrument. Qualification of personnel • The Leica HI1220 may be operated by trained laboratory personnel only. • All laboratory personnel designated to operate this instrument must read these Instructions... -
Page 7: Safety
• Be sure to read these notes even if you are already familiar with the operation and use of other Leica products. • The protective devices located on the instrument and the accessories must not be removed or modified. Only qualified service personnel authorized by Leica may repair the instrument and access its internal components. Residual risks •... -
Page 8: Warnings
To ensure trouble-free operation of the instrument, make sure to comply with the following instructions and warnings. Please note that electrostatic charge may result through direct or indirect contact with the Leica HI1220. Instructions for Use V 3.3 RevG – 07/2016... -
Page 9: Instrument Components And Specifications
Pollution degree: 2 Overvoltage category: II Operating temperature range: +15 °C to +40 °C Temperature control range: Room temperature to 75 °C Operating elevation: maximum of 2000 m above sea level IP protection class (IEC 60529): IP20 Leica HI1220 Flattening Table... -
Page 10: Instrument Setup
Check the delivery carefully against the packing list, delivery note and your order. Should you find any discrepancies, please contact your Leica sales office without delay. Instructions for Use V 3.3 RevG – 07/2016... -
Page 11: Unpacking And Setting Up The Hi1220
Instrument Setup Unpacking and setting up the HI1220 Set the carton on a flat surface, cut through the adhesive tape (Fig. 2) and open the carton (Fig. Fig. 2 Fig. 3 Hold the instrument firmly with one hand, pull off... -
Page 12: Operation
Operation Control panel fields on the instrument POWER LED Is illuminated when the instrument is switched on with the main power switch. Indicates the selected target tempera- ture. Set key: lower temperature. Set key: increase temperature. RUN/STOP Switch instrument on or off. 10 = Display Fig. -
Page 13: Setting The Temperature
Switching off the instrument • The instrument can be switched off by pressing the RUN/STOP key. You do not have to switch the main power switch on or off each time for everyday routine use. Leica HI1220 Flattening Table... -
Page 14: Cleaning And Maintenance
Cleaning and Maintenance Cleaning the instrument • Before cleaning the instrument, turn off using the power switch (Fig. 6, 3) and disconnect from the power supply. • The instrument has a continuous front panel and no lateral cooling slots, so the surfaces are smooth and easy to clean. -
Page 15: Warranty And Service
Leica Biosystems Nussloch GmbH guarantees that the contractual prod- uct delivered has been subjected to a comprehensive quality control procedure based on the Leica in-house testing standards, and that the product is faultless and complies with all technical specifications and/ or characteristics warranted. -
Page 16: Decontamination Certificate (Master)
Dear Customer, Any product that is to be returned to Leica Biosystems or serviced on site, must be cleaned and decontaminated in the appropriate manner. Since it is not possible to decontaminate for prion diseases, such as CJD, BSE, CWD etc., equipment exposed to specimens containing prion diseases cannot be returned to Leica Biosystems for repair. - Page 17 Such equipment must not be returned without the written agreement of Leica Biosystems. Decontamination Certificate (Master) The equipment has been prepared to ensure safe handling/transportation. Whenever possible, please use the original transportation case/box. Important - to avoid refusal of shipment: Place one copy in the unit prior to packaging, or hand it over to the service engineer.
- Page 18 Notes Instructions for Use V 3.3 RevG – 07/2016...
- Page 20 Leica Biosystems Nussloch GmbH Heidelberger Straße 17-19 D- 69226 Nussloch Phone: +49 6224 - 143 0 Fax: +49 6224 - 143 268 Web: www.LeicaBiosystems.com...
Need help?
Do you have a question about the HI1220 and is the answer not in the manual?
Questions and answers
Guten Abend, Ich brauche preis für Leica HI 1220. Wenn ist auf der large ich möchte gerne kaufen.
The price of the Leica HI 1220 is US $325.22 (approximately £251.12). The estimated delivery dates are between Tuesday, March 18, and Monday, March 24.
This answer is automatically generated