Table of Contents
Advertisement
EEC - SAFETY DATA SHEET
Gem. 91/155/EG; 2001/58/EG
Dated:
February 28st 2011 / innovatek Protect application mixture
6. Accidental release measures
Personal precautions:
Environmental pre-
cautions:
Methods for cleaning
up / taking up:
7. Handling and storage
Handling:
Protection against
fire and explosion:
Storage:
8. Exposure controls and personal protection
Components with workplace control parameters:
107-21-1: Ethylene glycol
Personal protective equipment
Respiratory Protection:
Hand protection:
Eye protection:
General safety and
hygiene measures:
9. Physical and chemical properties
Form:
Colour:
Odour:
pH value ( 500 g/l, 20 °C):
Solidification temperature:
Boiling point/range:
Flash point:
Lower explosion limit:
Figure 221:
innovatek Protect application mixture safety data sheet page 2
Avoid excessive contact with skin and eyes. In case of release
of larger amounts remove contaminated clothing and wash bo-
dy down thoroughly with water. Hand protection. Pick up im-
mediately as product renders floors slippery.
Contain contaminated water/firefighting water. Do not discharge
product into natural waters without pretreatment (biological
treatment plant).
Bind the liquid by using suitable absorbent material (saw dust,
sand, etc.) and dispose of in accordance with the regulations.
Wash away spills thoroughly with large quantities of water. In
case of release of larger quantities which might flow into the
draining system or waters, contact appropriate authorities.
Ensure thorough ventilation of stores and work areas.
Take precautionary measures against static discharges.
If exposed to fire, keep containers cool by spraying with water.
Product is hygroscopic. Containers should be stored tightly
sealed in a dry place. Storage in galvanized containers is not
recommended.
MAK value (D): 26 mg/m³ = 10 ppm (TRGS 900 (DE)). Top limit
category 1. There is no reason to fear a risk of damage to the
developing embryo when the MAK value is adhered to. Skin
resorption hazard: wear suitable gloves (see below).
Do not inhale gases/vapours/aerosols.
Chemical resistant protective gloves (EN 374). Recommended:
nitrile rubber, protective index 6. Manufacturers directions for
use should be observed because of great diversity of types.
Safety glasses with side-shields (frame goggles, EN 166)
The usual precautions for the handling of chemicals must
be observed.
Liquid
Colourless
Product specific
7.0 - 9.0
< -10 °C (DIN/ISO 3016)
>= 105 °C
>120 °C (only valid für the Ethylenglykol part)(DIN/ISO 2592)
3.0 % vol. (only valid für the Ethylenglykol – part)
Appendix
innovatek OS GmbH
www.innovatek.de
info@innovatek.de
(ASTM D 1120)
2
261
Advertisement
Table of Contents
