Subaru Legacy 2002 Service Manual page 52

B: PDI PROCEDURE
Follow the procedures shown in the table below.
Static Checks Just After Vehicle Receipt
Step
1. Appearance check
2. Tire check
3. Fuse installation
4. Connection of air conditioner harness
5. Check the doors for lock/unlock and open/
close operations.
6. Check the trunk lid open/close operations.
7. Check the rear gate for lock/unlock and open/
close operations.
8. Operation check of fuel lid opener lock release
lever
9. Accessory check
10. Operation check of hood lock release system
11. Battery
12. Brake fluid
13. Engine oil
14. Transmission fluid
15. AT front differential oil
16. Coolant
17. Clutch fluid
18. Window washer fluid
19. Hood latch check
20. Keyless entry system
PRE-DELIVERY INSPECTION
SA09719G50
(1) If the vehicle is covered with protective coating, visually check the
vehicle body for damage and dents. If the protective coating has been
removed, visually check the body paints for small areas of damage or
stains.
(2) Visually check the glass and light lenses for any damage and cracks
or excessive gaps to the body sheet metal.
(3) Visually check the plated parts for any damage.
(1) Check the tires for damage, abnormal conditions, and dents on the
wheels.
(2) Check the tire air pressure.
(1) If the vehicle is about to be delivered to the customer, attach a room
lamp fuse.
(1) If the vehicle is about to be delivered to the customer, connect the air
conditioner harness.
(1) Using the key, check if the door can be locked and unlocked normally.
(2) Open and close the all doors to see that there are no abnormal condi-
tions.
(1) Operate the trunk lock release lever to check that the trunk opens nor-
mally.
(2) Using the key, check if the trunk lid can be unlocked normally.
(3) Open and close the trunk lid to see that there are no abnormal condi-
tions.
(1) Using the key, check if the rear gate can be lock and unlocked nor-
mally.
(2) Open and close the rear gate to see that there are no abnormal condi-
tions.
(3) Operate the power door locking switch to check that the rear gate is
locked and unlocked normally.
(1) Operate the fuel lid opener to check that the fuel lid is unlocked nor-
mally.
Check the following accessories are provided:
¼ Owner's manual
¼ Warranty booklet
¼ Service booklet
¼ Spare key
¼ Jack
¼ Tool set
¼ Spare tire
(1) Operate the hood lock release lever to check that the hood opens nor-
mally.
(1) Check the battery for any abnormal conditions such as rust and trace
of battery fluid leaks.
(1) Check the fluid amount.
(1) Check the oil amount.
(1) Check the fluid amount.
(2) For AT, check the front differential oil.
(1) Check the AT front differential oil amount.
(1) Check the coolant amount.
(1) Check the clutch fluid amount.
(1) Check the window washer fluid amount.
(1) Check that the hood is closed and latched securely.
(1) Check that the keyless entry system operates normally.
PI-3
Pre-delivery Inspection
Check point