Subaru Legacy 2002 Service Manual page 53

Pre-delivery Inspection
Step
21. Seat
22. Seat belt
23. Wheel alignment
Checks with the Engine Running
Step
1. Read memory and test mode connectors
2. Starting condition
3. Exhaust system
4. Indicator light
5. Clock
6. Radio
7. Cigarette lighter
8. Lighting system
9. Window washer
10. Wiper
11. Power window operation check
Dynamic Test with the Vehicle Running
Step
1. Brake test
2. Parking brake
3. AT shift control
4. Heater & ventilation
5. Air conditioner
6. Cruise control
Checks after Dynamic Test
Step
1. ATF level
2. Power steering fluid level
3. Fluid leak check
4. Water leak check
5. Appearance check 2
PRE-DELIVERY INSPECTION
(1) Check the seat surfaces for smears or dirt.
(2) Check the seat installation conditions and functionality.
(1) Check the seat belt installation conditions and functionality.
(1) Check that the wheel alignments are properly adjusted.
(1) Read memory and test mode connectors
(1) Start the engine and check that the engine starts smoothly.
(1) Check that the exhaust noise is normal and no leaks are found.
(1) Check that all the indicator lights operate normally.
(1) Check that the clock operate normally.
(1) Check that the radio system operates normally.
(1) Check that the cigarette lighter operates normally.
(1) Check that the lighting systems operate normally.
(1) Check that the window washer system operates normally.
(1) Check that the wiper system operates normally.
(1) Check the power window for correct operations.
(1) Check that the foot brake operates normally.
(1) Check that the parking brake operates normally.
(1) Check the AT shift patterns are correct.
(1) Check that the heater & ventilation system operates normally.
(1) Check that the air conditioner operates normally.
(1) Check that the cruise control system operates normally.
(1) Check that the ATF level is normal.
(1) Check that the power steering fluid level is normal.
(1) Check for fluid/oil leaks.
(1) Spray the vehicle with water and check for water leaks.
(1) Remove the protective coating (if any).
(2) Check the body paints for damage and smears.
(3) Check the plated parts for damage and rust.
PI-4
Check point
Check point
Check point
Check point