Figure 37: Wrap Wire Strands; Figure 38: Remove Power/Alarm Connector - Allied Telesis AT-IS230-10GP Installation Manual

Chapter 5: Power On Switch
82
Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation.  E10
2. Tightly wrap the wire strands with your finger tips. Refer to Figure 37
on page 82.
This step is to prevent loose strands from touching other wires and
causing an electrical short.
Note
Allied Telesis recommends that you also tin the wires with solder as
added protection against loose strands. This guide does not provide
instructions on how to tin wires.
3. On the AT-IS230-10GP switch, loosen the two fastening screws on the
sides of the Power/Alarm connector.
Note
The AT-IS130-6GP switch Power/Alarm connector does not have
connector fastening screws.
4. Remove the power/alarm connector from the top panel. Figure 38
shows the removal of this connector.
Figure 38. Remove Power/Alarm Connector
Figure 37. Wrap Wire Strands