Review Site Requirements - Allied Telesis AT-IS230-10GP Installation Manual

Chapter 2: Begin Installation

Review Site Requirements

56
Please observe the following requirements and guidelines when choosing
a site for the IS Series switch:
You can install the switch on a concrete or masonry wall or

industrial panel or DIN 35x7.5mm rail.
The DC power source should be located near the device and be

easily accessible.
The site should allow for easy access to the ports on the front of

the device, so that you can easily connect and disconnect cables,
and view the port LEDs.
The site should allow for adequate air flow around and through the

cooling fins on the sides of the switch.
The site should not expose the device to moisture or water.

The site should be a dust-free environment.

The site should include dedicated power circuits or power

conditioners to supply reliable electrical power to the network
devices.
If you are installing the device in a wiring or utility box, verify that

the enclosure has adequate airflow so that unit does not overheat.
Do not place objects on top of the switch.

The twisted-pair cabling should not be exposed to sources of

electrical noise, such as radio transmitters, broadband amplifiers,
power lines, electric motors, and fluorescent lights.
The site should allow for the following minimum open spaces

around the switch:
– Four inches under the switch.
– Eight inches above the switch.
– Four inches in front of the switch.
– One inch on the left and right sides of the switch.
Before installing the DC power supply, be sure to review the

manufacturer's installation guide for rules and restrictions on site
requirements, and to follow all guidelines and safety warnings.