Connecting The Grounding Wire With Bare Wire; Figure 64: Stripping The Solid Or Stranded Grounding Wire; Figure 65: Attaching The Bare Grounding Wire To The Grounding Post - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Connecting the
Grounding Wire
with Bare Wire
To attach the grounding wire to the power supply with bare wire, perform
the following procedure:
1. Prepare an adequate length of solid or stranded 10 AWG grounding
wire by stripping it as shown in Figure 64.
Figure 64. Stripping the solid or Stranded Grounding Wire
2. Verify that the On/Off switch on SBxPWRSYS1-80 DC Power Supply
is in the Off position. Refer to Figure 60 on page 97.
3. Use an 8 mm wrench to remove the grounding post nut and washer,
shown in Figure 61 on page 98, from the grounding post on the power
supply.
4. Wrap the grounding wire clockwise around the base of the grounding
post, as shown in Figure 65.
Figure 65. Attaching the Bare Grounding Wire to the Grounding Post
SBx908 GEN2 Installation Guide for Stand-alone Switches
101