Figure 31: Connect Fiber Optic Cable To Sfp Transceiver - Allied Telesis AT-IS230-10GP Installation Manual

5. Connect the fiber optic cable to the transceiver. The connector on the
cable should fit snugly into the port, and the tab should lock the
connector into place. Refer to Figure 31.
Figure 31. Connect Fiber Optic Cable To SFP Transceiver
6. For the AT-IS230-10GP switch, repeat this procedure to install and
connect the cable to the other SFP transceiver if required.
7. Go to Chapter 5, "Power On Switch" on page 77.
IS Series Industrial Ethernet Layer 2 Switch Installation Guide
This space is reserv
75