Figure 36: Wrapping The Wire Strands; Figure 37: Removing An Alarm Connector - Allied Telesis IE200 Series Installation Manual

Figure 36. Wrapping the Wire Strands
Note
Allied Telesis recommends that you also tin the wires with solder as
added protection against loose strands. This guide does not provide
instructions on how to tin wires.
3. Remove the alarm connector from the top panel. Figure 37 shows the
removal of the ALM OUT connector.
Figure 37. Removing an Alarm Connector
4. Loosen the wire retaining screws in the connector with a #1
screwdriver. Refer to Figure 38 on page 86.
IE200 Series Installation Guide
85