Din Rail Installation; Figure 21: Orientation Of The Switch On A Din Rail - Allied Telesis AT-IS230-10GP Installation Manual

Chapter 3: Install the Switch

DIN Rail Installation

64
Both IS Series switches come with a DIN rail bracket pre-installed on the
back panel. The bracket is compatible with a DIN 35x7.5mm rail. The
bracket has a spring built into it which holds the bracket in place.
Note
Figure 21, Figure 22, and Figure 23 below illustrate the
AT-IS230-10GP switch, but also apply to the AT-IS130-6GP switch.
Figure 21 shows the proper orientation of the switch on a DIN rail. Do not
install the switch horizontally or upside-down.
Figure 21. Orientation of the Switch on a DIN Rail
To install the switch on a DIN rail, perform the following procedure:
1. Slide the slot on the top of the DIN rail bracket onto the top edge of the
DIN rail. Refer to Figure 22.