Apply Power To Switch; Verify Switch Operations - Allied Telesis AT-IS230-10GP Installation Manual

Chapter 5: Power On Switch

Apply Power To Switch

Verify Switch
Operations
86
This section contains the procedure for powering on the switch.
To power on the chassis, perform the following procedure:
1. Apply power to the DC power supplies.
Note
The AT-IS230-10GP switch and AT-IS130-6GP switch do not have
an On/Off switch. To turn the unit OFF, you must turn OFF the
power supplies.
2. Wait a minimum of one minute for the switch to initialize its operating
system.
Here are items to check to verify that the switch is operating normally. If
there is a problem, refer to Chapter 6, "Troubleshooting" on page 91 for
suggestions on how to resolve it.
The Fault LED should be off.

One or both PWR 1 and PWR 2 LEDs should be solid green,

depending on the number of DC power supplies connected to the
unit.
The LEDs on SFP slots with transceivers connected to active

network devices should be solid or flashing green.
The Link LEDs on twisted-pair ports connected to active network

devices should be solid or flashing green or amber. The Link LEDs
are identified in Figure 9 on page 41 and Figure 11 on page 42.
The PoE LEDs should be solid green on ports that are connected

to PoE or PoE+ devices. The PoE LEDs are identified in Figure 13
on page 43.
If you have a AT-IS230-10GP switch, go to "Start Management Session"
on page 87.