Table of Contents
Advertisement
Chapter 2: Installing the Switch
Installing the Switch on a DIN Rail
28
The series switch comes with a DIN rail bracket pre-installed on the back
panel. The bracket is compatible with DIN 35x7.5mm rails.
Here is the procedure for installing the switch on a DIN rail:
1. See "Reviewing Safety Precautions" on page 22.
2. See "Choosing a Site for the Switch" on page 25.
3. Attach the 3-pin terminal block to the switch as shown in Figure 5 on
page 27n
4. While holding the switch with one hand, press the bracket from the top
and snap the bracket onto the DIN rail as shown in Figure 7.
Figure 7. Installing the Switch on the DIN Rail
5. Visually inspect the bracket to verify that the DIN rail is fitted into the
top and bottom slots.
6. Go to Chapter 4, "Cabling the Networking Ports" on page 35.
Advertisement
Table of Contents
