Command Groups - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

C L
OMMAND INE

Command Groups

The system commands can be broken down into the functional
groups shown below
Command
Group
General
Flash/File
System
Management
Authentication
SNMP
IP
Line
Interface
Address Table
Spanning Tree
VLAN
GVRP and
Bridge
Extension
3-12
I
NTERFACE
.
Description
Basic commands for entering privileged access
mode, restarting the system, or quitting the CLI
Manages code image or switch configuration
files
Controls system logs, system passwords, user
name, jumbo frame support, browser
management options, HTTPS, SSH, and a variety
of other system information
Configures RADIUS and TACACS+ client-server
authentication for logon access
Activates authentication failure traps; configures
community access strings, and trap managers
Configures the IP address and gateway for
management access, displays the default
gateway, or pings a specified device
Sets communication parameters for the serial
port, including baud rate and console time-out.
Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
Configures the address table for filtering
specified addresses, displaying current entries,
clearing the table, or setting the aging time
Configures Spanning Tree settings for the switch 3-113
Configures VLAN settings, and defines port
membership for VLAN groups
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for
bridge extension MIB
Page
3-14
3-20
3-27
3-55
3-64
3-73
3-80
3-91
3-107
3-130
3-141