Negotiation - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

Example
The following example configures port 5 to 100 Mbps, half-duplex
operation.
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Related Commands

negotiation (3-95)

capabilities (3-96)
negotiation
Use this command to enable autonegotiation for a given interface.
Use the no form to disable autonegotiation.
Syntax
negotiation
no negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When auto-negotiation is enabled the switch will negotiate the
best settings for a link based on the capabilities command.
When auto-negotiation is disabled, you must manually specify
the link attributes with the speed-duplex and flowcontrol
commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal
configuration will also be disabled for the RJ-45 ports.
I C
NTERFACE OMMANDS
3-95