Ip Igmp Snooping Query-Max-Response-Time - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

C L
OMMAND INE

ip igmp snooping query-max-response-time

Use this command to configure the snooping report delay. Use the
no form of this command to restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries.
(Range: 5-30)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The switch must be using IGMPv2 for this command to take
effect.
• This command defines the time after a query, during which a
response is expected from a multicast client. If a querier has
sent a number of queries defined by the ip igmp snooping
query-count, but a client has not responded, a countdown
timer is started using an initial value set by this command. If the
countdown finishes, and the client still has not responded, then
that client is considered to have left the multicast group.
Example
The following shows how to configure the maximum response
time to 20 seconds:
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#
3-156
I
NTERFACE