Flowcontrol - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

Default Setting
• 100BASE-TX: 10half, 10full, 100half, 100full
• 1000BASE-T: 10half, 10full, 100half, 100full, 1000full
• 1000BASE-SX/LX/LH: 1000full
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When auto-negotiation is enabled with the negotiation
command, the switch will negotiate the best settings for a link
based on the capabilites command. When auto-negotiation is
disabled, you must manually specify the link attributes with the
speed-duplex and flowcontrol commands.
Example
The following example configures Ethernet port 5 capabilities to
100half, 100full and flow control.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#

flowcontrol

Use this command to enable flow control. Use the no form to
disable flow control.
Syntax
flowcontrol
no flowcontrol
Default Setting
Flow control enabled
I C
NTERFACE OMMANDS
3-97