Spanning-Tree Port-Priority - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree cost 50
Console(config-if)#
Related Commands

spanning-tree port-priority (3-123)

spanning-tree port-priority
Use this command to configure the priority for the specified
interface. Use the no form to restore the default.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
priority - The priority for an interface. (Range: 0-240, in
steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of an interface in
the Spanning Tree Protocol. If the path cost for all interfaces on
a switch are the same, the interface with the highest priority
(that is, lowest value) will be configured as an active link in the
Spanning Tree.
• Where more than one interface is assigned the highest priority,
the interface with lowest numeric identifier will be enabled.
S T
PANNING REE
C
OMMANDS
3-123