Setting The Ip Address - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

CLI – Specify the hostname, location and contact information.
Console(config)#hostname Test Switch
Console(config)#snmp-server location TPS - 3rd Floor
Console(config)#snmp-server contact Chris
Console#show system
System description: SMC Networks SMC8612T
System OID string: 1.3.6.1.4.1.1991.1.5.1.1.4.1.1
System information
System Up time: 0 days, 2 hours, 4 minutes, and 7.13 seconds
System Name
System Location
System Contact
MAC address
Web server
Web server port
Web secure server
Web secure server port : 443
POST result
--- Performing Power-On Self Tests (POST) ---
UART Loopback Test ..................... PASS
Timer Test ............................. PASS
DRAM Test .............................. PASS
I2C Initialization ..................... PASS
Runtime Image Check .................... PASS
PCI Device Check ....................... PASS
Switch Driver Initialization ........... PASS
Switch Internal Loopback Test .......... PASS
------------------- DONE --------------------
Console#

Setting the IP Address

An IP address may be used for management access to the switch
over your network. By default, the switch uses DHCP to assign IP
settings to VLAN 1 on the switch. If you wish to manually
configure IP settings, you need to change the switch's
user-specified defaults (IP address 0.0.0.0 and netmask 255.0.0.0)
to values that are compatible with your network. You may also
need to a establish a default gateway between the switch and
management stations that exist on another network segment.
: Test Switch
: TPS - 3rd Floor
: Chris
: 00-30-f1-47-58-3a
: enable
: 80
: enable
B C
ASIC ONFIGURATION
3-29
3-66
3-66
3-52
2-11