SMC Networks GS16 User Manual
  1. Manuals
  2. Brands
  3. SMC Networks Manuals
  4. Switch
  5. GS16
  6. User manual

SMC Networks GS16 User Manual

Ez switch 10/100/1000 mbps 16/24-port auto-sensing gigabit switch
Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Related Manuals for SMC Networks GS16

Summary of Contents for SMC Networks GS16

  • Page 3 EZ Switch 10/100/1000 User Guide From SMC’s EZ line of low-cost workgroup LAN solutions 38 Tesla Irvine, CA 92618 April 2005 Phone: (949) 679-8000 Pub. # 150000017200H R01...
  • Page 4 No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice.
  • Page 5 Life of that Product, which is defined as the period of time during which the product is an “Active” SMC product. A product is considered to be “Active” while it is listed on the current SMC price list. As new technologies emerge, older technologies become obsolete and SMC will, at its discretion, replace an older product in its product line with one that incorporates these newer technologies.
  • Page 6 RIGHTS, WHICH MAY VARY FROM STATE TO STATE. NOTHING IN THIS WARRANTY SHALL BE TAKEN TO AFFECT YOUR STATUTORY RIGHTS. * SMC will provide warranty service for one year following discontinuance from the active SMC price list. Under the limited lifetime warranty, internal and external power supplies, fans, and cables are covered by a standard one-year warranty from date of purchase.
  • Page 7 • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help EC Conformance Declaration - Class A SMC contact for these products in Europe is: SMC Networks Europe, Edificio Conata II, Calle Fructuós Gelabert 6-8, 2 08970 - Sant Joan Despí,...
  • Page 8 OMPLIANCES • Electrostatic Discharge according to EN 61000-4-2:1995 (Contact Discharge: ±4 kV, Air Discharge: ±8 kV) • Radio-frequency electromagnetic field according to EN 61000-4-3:1996 (80 - 1000 MHz with 1 kHz AM 80% Modulation: 3 V/m) • Electrical fast transient/burst according to EN 61000-4-4:1995 (AC/DC power supply: ±1 kV, Data/Signal lines: ±0.5 kV) •...
  • Page 9 OMPLIANCES Please read the following safety information carefully before installing the Switch: WARNING: Installation and removal of the unit must be carried out by qualified personnel only. • This guide is intended for use by network administrators who are responsible for setting up and installing network equipment; consequently it assumes a basic working knowledge of LANs (Local Area Networks).
  • Page 10 OMPLIANCES France and Peru only This unit cannot be powered from IT † supplies. If your supplies are of IT type, this unit must be powered by 230 V (2P+T) via an isolation transformer ratio 1:1, with the secondary con- nection point labelled Neutral, connected directly to earth (ground).
  • Page 11 OMPLIANCES • Vous devez raccorder ce groupe à une sortie mise à la terre (mise à la masse) afin de respecter les normes internationales de sécurité. • Le coupleur d’appareil (le connecteur du groupe et non pas la prise murale) doit respecter une configuration qui permet un branchement sur une entrée d’appareil EN 60320/IEC 320.
  • Page 12 OMPLIANCES Cordon électrique - Il doit être agréé dans le pays d’utilisation Suisse: La prise mâle d’alimentation doit respecter la norme SEV/ASE 1011. Europe La prise secteur doit être conforme aux normes CEE 7/7 (“SCHU- KO”) LE cordon secteur doit porter la mention <HAR> ou <BASEC> et doit être de type HO3VVF3GO.75 (minimum).
  • Page 13 OMPLIANCES Stromkabel. Dies muss von dem Land, in dem es benutzt wird geprüft werden: Schweiz Dieser Stromstecker muß die SEV/ASE 1011Bestimmungen ein- halten. Europe Das Netzkabel muß vom Typ HO3VVF3GO.75 (Mindestan- forderung) sein und die Aufschrift <HAR> oder <BASEC> tragen. Der Netzstecker muß...
  • Page 14 OMPLIANCES Environmental Statement The manufacturer of this product endeavours to sustain an environmentally-friendly policy throughout the entire production process. This is achieved though the following means: • Adherence to national legislation and regulations on environmental production standards. • Conservation of operational resources. •...
  • Page 15 OMPLIANCES Safety Compliance Warning: Fiber Optic Port Safety When using a fiber optic port, never look at the transmit laser while CLASS I it is powered on. Also, never look directly at the fiber TX port and LASER DEVICE fiber cable ends when they are powered on. Avertissment: Ports pour fibres optiques - sécurité...
  • Page 16 OMPLIANCES...

  • Page 17: Table Of Contents

    ABLE OF ONTENTS Introduction ........1 Features and Benefits .
  • Page 18 viii...

  • Page 19: Introduction

    EATURES AND ENEFITS NTRODUCTION The EZ Switch™ 10/100/1000, SMCGS16 and SMCGS24, are high-performance Gigabit Ethernet switches designed for delivering Gigabit connectivity to the desktop. They provide 16/24 full-duplex 1000BASE-T ports that significantly improve network performance and boost throughput for high-bandwidth applications. With 32/48 Gigabits of throughput bandwidth, these switches provide the quickest solution to meeting the growing demands on your network.

  • Page 20: Front Panel Rj-45 Ports

    NTRODUCTION Front Panel RJ-45 Ports The EZ Switch 10/100/1000 features 16/24 1000BASE-T ports with RJ-45 connectors located on the front panel of the switch. Because all ports support automatic MDI/MDI-X operation, you can use straight-through cables for all network connections to PCs or servers, or to other switches or hubs.

  • Page 21: Smcgs16

    ANEL SMCGS16 SMCGS24 Rear Panel The AC power connector is located on the rear panel of the switch.

  • Page 22: Installing The Switch

    • Four rubber foot pads • Rack-mount bracket kit • Appropriate AC power cord • This User Guide • SMC Warranty Registration Card Selecting a Site Be sure to follow the site selection guidelines below when choosing a location: •...

  • Page 23: Instructions

    NSTRUCTIONS • There should be adequate space (approximately two inches) on all sides for proper air flow. • Make sure twisted-pair cable is always routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference such as radios, transmitters, etc. •...
  • Page 24 NSTALLING THE WITCH Note: If an attached device does not support auto-negotiation, the data rate will be sensed automatically and the communication mode will default to half duplex. 4. Cascading Switches and Other Network Devices: All the ports on the switch support automatic MDI/MDI-X configuration for cable connections.

  • Page 25: Application Example

    NSTRUCTIONS PPLICATION XAMPLE A typical application for the SMCGS16 is illustrated below. EZ Switch 10/100/1000 SMCGS16 Server Internet SMC-EZ109DT Link Activi WLAN Notebook SMC2804WBR Wireless Broadband Router Workstations With SMC9452TX Gigabit Workstations PCI Cards Notebook with SMC2835W Wireless PC Card...

  • Page 26: Troubleshooting

    ROUBLESHOOTING ROUBLESHOOTING Diagnosing Switch Indicators 1. Symptom Power LED does not light after power on. Probable Causes • AC power cord may be defective. Possible Solutions • Check for loose connections. • Check the power outlet by using it for another device. •...

  • Page 27: Cables

    ABLE PECIFICATIONS ABLES Cable Specifications Cable Types and Specifications Cable Type Max. Length Connector 10BASE-T 2-pair Cat. 3 or better 100-ohm UTP 100 m (328 ft) RJ-45 100BASE-TX 2-pair Cat. 5 or better 100-ohm UTP 100 m (328 ft) RJ-45 1000BASE-T 4-pair Cat.

  • Page 28: 1000Base-T Pin Assignments

    ABLES The table below shows the 10BASE-T/100BASE-TX MDI-X and MDI port pinouts. MDI-X Signal Name MDI Signal Name Receive Data plus (RD+) Transmit Data plus (TD+) Receive Data minus (RD-) Transmit Data minus (TD-) Transmit Data plus (TD+) Receive Data plus (RD+) Transmit Data minus (TD-) Receive Data minus (RD-) 4,5,7,8...

  • Page 29: 1000Base-T Cable Requirements

    1000BASE-T C ABLE EQUIREMENTS 1000BASE-T Cable Requirements All Category 5 UTP cables that are used for 100BASE-TX connections should also work for 1000BASE-T, providing that all four wire pairs are connected. However, it is recommended that for all critical connections, or any new cable installations, 4-pair Category 5e (enhanced Category 5) cable should be used.

  • Page 30: Product Specifications

    RODUCT PECIFICATIONS RODUCT PECIFICATIONS EZ Switch 10/100/1000 Standards Conformance IEEE 802.3-2002 Ethernet, Fast Ethernet, Gigabit Ethernet Full-duplex flow control Communication Rate 10, 100, and 1000 Mbps Communication Mode Full or half duplex at 10/100 Mbps Full duplex at 1000 Mbps Media Supported 10BASE-T: 100-ohm Category 3 or better twisted-pair 100BASE-TX: 100-ohm Category 5 or better twisted pair...
  • Page 31 EZ S 10/100/1000 WITCH Weight SMCGS16: 2.0 kg (4.04 lbs) SMCGS24: 2.2 kg (4.85 lbs) MAC Address Table 8 K entries Memory Buffer SMCGS16: 272 Kbits on-chip frame buffer SMCGS24: 400 Kbits on-chip frame buffer Power Consumption SMCGS16: 15.8 Watts SMCGS24: 24.2 Watts Heat Dissipation 130 BTU/hr maximum...
  • Page 32 RODUCT PECIFICATIONS...
  • Page 34 Fax (65) 238 6466 Korea: 82-2-553-0860 Fax 82-2-553-7202 Japan: 81-45-224-2332 Fax 81-45-224-2331 Australia: 61-2-8875-7887 Fax 61-2-8875-7777 India: 91-22-8204437 Fax 91-22-8204443 If you are looking for further contact information, please visit www.smc.com. Model Number: SMCGS16/SMCGS24 38 Tesla Irvine, CA 92618 Phone: (949) 679-8000...

This manual is also suitable for:

Gs24Smcgs16Smcgs24

Table of Contents