Switchport Priority Default - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

Command
show map ip
precedence
show map ip dscp Shows the IP DSCP map

switchport priority default

Use this command to set a priority for incoming untagged frames,
or the priority of frames received by the device connected to the
specified interface. Use the no form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged
ingress traffic. The priority is a number from 0 to 7. Seven is
the highest priority.
Default Setting
The priority is not set, and the default value for untagged
frames received on the interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Precedence or IP
DSCP, and default switchport priority.
• The default priority applies for an untagged frame received on
a port set to accept all frame types (i.e, receives both untagged
and tagged frames). This priority does not apply to IEEE 802.1Q
VLAN tagged frames. If the incoming frame is an IEEE 802.1Q
VLAN tagged frame, the IEEE 802.1p User Priority bits will be
used.
Function
Shows the IP precedence map
P C
RIORITY OMMANDS
Mode Page
PE 3-171
PE 3-172
3-161