Speed-Duplex - SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Management Manual

C L
OMMAND INE

speed-duplex

Use this command to configure the speed and duplex mode of a
given interface when autonegotiation is disabled. Use the no form
to restore the default.
Syntax
speed-duplex {1000full | 100full | 100half | 10full |
10half}
no speed-duplex
• 1000full - Forces 1000 Mbps full-duplex operation
• 100full - Forces 100 Mbps full-duplex operation
• 100half - Forces 100 Mbps half-duplex operation
• 10full - Forces 10 Mbps full-duplex operation
• 10half - Forces 10 Mbps half-duplex operation
Default Setting
• Auto-negotiation is enabled by default.
• When auto-negotiation is disabled, the default speed-duplex
setting is 1000full for Gigabit Ethernet ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To force operation to the speed and duplex mode specified in
a speed-duplex command, use the no negotiation command
to disable auto-negotiation on the selected interface.
• When using the negotiation command to enable
auto-negotiation, the optimal settings will be determined by the
capabilities command. To set the speed/duplex mode under
auto-negotiation, the required mode must be specified in the
capabilities list for an interface.
3-94
I
NTERFACE