Table of Contents
Advertisement
Figure 46. Installing the PERC card
Next steps
1.
Install the expansion card
2. Follow the procedure listed in the
System battery
Replacing the system battery
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Push the battery holder clip away from the battery.
CAUTION:
To avoid damage to the battery holder clip, ensure that you do not bend the battery holder clip
while installing or removing a battery.
2. Pull the battery out of the battery holder.
NOTE:
Ensure that the + side of the battery is facing the battery holder clip.
48
Installing and removing system components
riser.
After working inside your
Safety
instructions. that came with your system for more information.
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
