System Battery; Replace The System Battery; Removing The System Battery - Dell EMC XC Core XC6515 Installation And Service Manual

NOTE: While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more
information about the Part replacement configuration, see the
idracmanuals

System battery

Replace the system battery

Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the safety instructions that came with your system for more information.
• Follow the safety guidelines listed in the
• Follow the procedure listed in the
• If applicable, disconnect the power or data cables from the expansion card(s).
• Remoe the LOM riser card.
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
Figure 79. Removing the system battery
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2. To install a new system battery: To install a new system battery,
a. Hold the battery with the positive side facing up and slide it under the securing tabs.
b. Press the battery into the connector until it snaps into place.
106 Installing and removing system components
Safety instructions.
Before you work inside your
Lifecycle Controller User's Guide at
system.
www.dell.com/