System Battery; Replacing The System Battery - Dell EMC PowerEdge T340 DPJ1G Installation And Service Manual

Next steps
1 Install the air shroud
2 Replace the PSUs.
3 Follow the procedure that is listed in

System battery

Replacing the system battery

Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type that the manufacturer recommends. Discard used batteries according to the manufacturer's instructions. See
the safety instructions that came with your system for more information.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
Steps
1 Locate the system battery on the system.
2 To remove the battery:
a Push the battery toward the positive side of the battery until the battery disengages from the connector.
b Lift the battery away from the system.
Figure 78. Removing the system battery
3 To install a new system battery:
a Hold the battery with the + sign facing the positive side of the battery connector.
NOTE: Ensure that you do not push the battery clip more than 3.2 millimeters or you might risk damaging the part.
b Insert the battery down into the connector until the battery snaps into place.
104 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.