Figure 109. Installing the PERC card
Next steps
1.
Install the air
shroud.
2. If removed,
replace the expansion card
3. If removed,
replace the rear drive
4.
Install the PERC card air
5. Follow the procedure listed in
System battery
Replacing the system battery
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same
or equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. Locate the battery socket. For more information, see the System board jumpers and connectors section.
Steps
1. Use a plastic scribe and Press the release latch until the battery pops out.
NOTE:
Ensure that the + side of the battery is facing upwards.
riser.
cage.
shroud.
After working inside your system
Safety instructions
on page 43 that came with your system for more information.
Safety instructions
Before working inside your system
on page 44.
on page 43.
on page 44.
Installing and removing system components
121