Removing A 2.5-Inch Drive From A 3.5-Inch Drive Adapter - Dell EMC PowerEdge R240 Installation And Service Manual

Figure 24. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
2. If removed, install the front

Removing a 2.5-inch drive from a 3.5-inch drive adapter

Steps
1. Using a Phillips #1 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
NOTE: If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
2. Remove the drive from the 3.5-inch drive adapter.
bezel.
Installing and removing system components 31