Figure 59. Installing the drive backplane
Next steps
1
Connect all the cables to the backplane.
2
Install all the
drives.
3
Install the backplane
cover.
4
Install the air
shroud.
5
Follow the procedure listed in
Removing the rear drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION:
You must note the number of each hard drive and temporarily label them before removal so that you can replace them
in the same locations.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the drives from the rear drive cage.
4
Disconnect all the cables from the backplane.
5
Remove the rear drive
After working inside your
Safety
instructions.
Before working inside your
cage.
system.
system.
Installing and removing system components
101