Table of Contents
Advertisement
Figure 135. Installing mid drive tray backplane
Next steps
1. Connect all the cables to the backplane.
2.
Install all the drives carriers into the mid drive
3. Follow the procedure listed in
Removing the 3.5 inch drive rear backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION:
You must note the number of each drive and temporarily label them before removal so that you can replace
them in the same locations.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove all the
drives.
4. Disconnect all the cables from the backplane.
Steps
1. Pull the release pins, and lift the drive backplane to disengage the backplane from the hooks on the rear drive module.
2. Remove the backplane from the system.
178
Installing and removing system components
tray.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
