Table of Contents
Advertisement
Figure 113. Installing the mid drive tray backplane
Next steps
1
Connect all the cables to the backplane.
2
Install all the drive carriers into the mid drive
3
Follow the procedure listed in
Removing the 3.5 inch rear drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION:
You must note the number of each drive and temporarily label them before removal so that you can replace them in
the same locations.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the drives from the rear drive
4
Disconnect all the cables from the backplane.
Steps
1
Pull the release pins, and lift the drive backplane to disengage the backplane from the hooks on the rear drive cage.
2
Remove the backplane from the system.
tray.
After working inside your
system.
Safety
instructions.
Before working inside your
cage.
system.
Installing and removing system components
153
Advertisement
Table of Contents
