Table of Contents
Advertisement
Figure 95. Installing the MicroSD card
Next steps
1.
Install the IDSDM
module.
2. Follow the procedure listed in
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS card. The BOSS card removal is similar to
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the BOSS card connector.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your system
Safety instructions
Before working inside your system
on page 26.
on page 25.
on page 26.
removing expansion card from the expansion card
Installing and removing system components
riser.
99
Advertisement
Table of Contents
