Table of Contents
Advertisement
Figure 93. Connecting the FPGA cable for the accelerator card
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air shroud.
4.
Remove the BOSS card
NOTE:
The procedure to remove the BOSS card is similar to removing an expansion card.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to remove it from the BOSS card.
NOTE:
The numbers on the image does not depict the exact steps. The numbers are just for representation of
sequence.
After working inside your system
Safety instructions
Before working inside your system
from the riser.
on page 44.
on page 43.
on page 44.
Installing and removing system components
107
Advertisement
Table of Contents
