M.2 Ssd Module; Removing The M.2 Ssd Module; Installing The M.2 Ssd Module - Dell EMC PowerEdge T340 DPJ1G Installation And Service Manual

M.2 SSD module

Removing the M.2 SSD module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to removing an expansion card.
Steps
1 Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2 Pull the M.2 SSD module to disconnect from the BOSS card connector.
Figure 60. Removing the M.2 SSD module
Next step
Replace the M.2 SSD module.

Installing the M.2 SSD module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 87