Module Select Rear; More N/M - HP 8360 L Series User Manual

Module Select Rear

Function Group
Menu Map
Description
Programming Codes
See Also

more n/m

Function Group
Menu Map
Description
Programming Codes
See
POWER and FREQUENCY
2 and 5
This command causes the swept CW generator to examine only
the rear panel source module interface connector to determine
the type of source module (if any) connected. The instrument
frequency limits and multiplier are altered according to the source
module connected. However, the leveling point is not changed. See
Leveling Point
the output of the source module.
An asterisk next to the key label indicates this feature is active.
SYSTem:MMHead:SELect FRONtlREARlNONE
SYSTem:MMHead:SELect?
Analyzer:
NONE
Module Menu
ALL FUNCTION GROUPS
ALL MENU MAPS
The more n/m softkey allows you to page through the menus. Look
at one of the menu maps. Notice the line (keypath) drawn from
more n/m. By selecting this softkey, the next page of the menu is
revealed. If you are viewing the last page of the menu, selecting
more n/m returns the first page of the menu. In this softkey "n"
represents the page you are on and "m" represents the total number
of pages in the menu.
SCPI:
Not Applicable
Analyzer:
Not Applicable
Also
Module
to set the swept CW generator to level at
Operating and Programming Reference M-13
more n/m