Use Of The Command Tables - HP 8360 L Series User Manual

Command
1-88 Getting Started Programming

Use of the Command Tables

In Table 1-4, notice that a new column titled "Allowed Values" has
been added to the command table. This column lists the specific
values or range of values allowed for each parameter. A vertical bar
The commands listed in the table are only part of all the available
SCPI commands of the swept CW generator. For a complete listing
of the programming codes see "SCPI Command Summary" in
Chapter 2.
Table 1-4. Sample Swept CW Generator Commands
Parameters Parameter Type
discrete
to cal
measured power extended numeric
extended numeric
801 freq-
correction pairs
extended numeric
center freq
CW freq extended numeric
coupled to Boolean
center freq
discrete
free mode
start freq extended numeric
Boolean
auto freq step
extended numeric
stop freq extended numeric
extended numeric
marker frequency
Allowed Values
specified freq
range
or
specified freq range
or MAXimum]MINimum]UP]DOWN
specified freq range
or MAXimum]MINimum]UP]DOWN
20 to 0.01 dB or
specified freq range
or
[n] is 1 to 5, 1 is the
default
specified freq range
or MAXimumlMINimum