HP 8360 L Series User Manual page 411

Index-6
disable interface address changes, 3-8
disable save, S-l
disable user flatness array, C-11
discrete parameters
discussed in detail, l-85
explained briefly, l-75
discrete response data
discussed in detail, l-86
display, l-4
display blank, B-l
display, clean, 4-6
display clear, B-l
display status, D-5
display status of phase-lock-loops, U-l
display zero frequency, Z-l
doubler amp mode auto, D-6
doubler amp mode off, D-7
doubler amp mode on, D-8
doubler amp softkeys, D-l
down arrow, A-16
dual source control, S-56
dwell coupled, D-8
dwell time
frequency point, E-2
list array, all points, G-l
stepped frequency mode, S-59
dwell time coupled, D-8
EEROM fail, F-3
E
EEROM failed, lost CAL message, 2a-2
EEROM failed message, 2a-2
enable register, l-107
in general status register model, l-106
ending frequency
flatness correction, A-21
frequency list, A-2 1
enter correction, E-l
enter frequency value
flatness, E-2
enter list dwell, E-2
enter list frequency, E-3
enter list offset, E-3
enter statement, 1-61
entry area, l-4, E-4
entry keys, E-4
entry on LED, l-5
entry on/off, E-4
EOI, l-64, 1-81
EOL, suppression of, 1-61
equipment supplied, 3-l
erase active array entry, D-2
erase array, D-2