HP 8360 L Series User Manual page 161

ANALYZER STATUS REGISTER
7
B i t #
128
Decimal
Value
Function
SRQ on new REQUEST
frequencies
time in
effect.
7
B i t #
128
Decimal
Value
Function
Fault
Indicator
On
A-14 Operating and Programming Reference
STATUS BYTE (#1)
6
5
64
32
SRQ on
SERVICE HP-IB or
syntax error. Sweep
EXTENDED STATUS BYTE (#2)
6
5
32
64
RF Unleveled Power
Failure
Status Byte 1
Bit 0: SRQ caused by a key closure on the front panel of the swept
CW generator (use the OM code to determine the front panel
status).
Bit 1: SRQ caused by the completion of a numeric entry (use the OA
code to determine the value of the numerical entry).
Bit 2: SRQ caused by a change in the extended status byte (status
byte 2) affected by the RE-coded mask (see the RE code for an
explanation of this masking).
Bit 3: SRQ caused by the completion of phase locking and the
settling of the RF source (use the OK code to determine the last lock
frequency).
Bit 4: SRQ on end-of-sweep or mid-sweep update in NA (network
analyzer code) mode.
Bit 5: SRQ caused by HP-IB syntax error.
Bit 6: SERVICE REQUEST; by IEEE-488 convention, the
instrument needs service from the controller when this bit is set true.
Bit 7: SRQ caused by a change in the coupled parameters (start
frequency, center frequency, and sweep time). Use the OC code to
determine the new values of the coupled parameters.
Status Byte 2 (Extended Status Byte)
Bit 0: Self test failed at power on or at Instrument Preset. This bit
remains latched until this status byte has been read, or until cleared
by the CS or CLEAR 719 commands.
Bit 1: Excessive amplitude modulation input.
3
4
16
8
SRQ on SRQ on
End of
RF Settled
3
4
a
6
RF Unlocked External
Frequency
Reference
Selected
2 1
4
2
SRQ on
Changed in Numeric
Extended Entry
status Completed
Byte
(HP-IB or
Front
1
2
4
2
Oven Over
Cold Modulation
0
1
SRQ on
Any Front
Panel Key
Pressed
0
1
Self Test
Failed