HP 8360 L Series User Manual page 343

Swept CW Generator
Specific SCPI Error
Messages
TRACE EXCEPTION:
processor error. Refer to Chapter 4 for instructions on contacting a
qualified service technician.
TRAP0 EXCEPTION:
processor error. Refer to Chapter 4 for instructions on contacting a
qualified service technician.
TRAP3 EXCEPTION:
processor error. Refer to Chapter 4 for instructions on contacting a
qualified service technician.
Too many test patches !!:
adjustment menu is accessed. Specifically, the maximum number of
test patches has been reached and can accept no more.
WAIT-SAVING CALIBRATION:
service adjustment menu is accessed. Specifically, a save calibration
has been initiated and not yet completed when another request is
made.
WRONG PASSWORD:
adjustment menu password is entered incorrectly or the wrong
password has been used. Qualified service technicians, refer
to "ADJUSTMENTS," in the
Generator/HP 8360 L-Series Swept CW Generator Service Guide
more information.
0, No Error:
This message indicates that the device has no errors
and is currently ready to perform the operations for which it is
designed.
1, FUNCTION DISABLED:
been disabled by a calibration constant. If you need access to the
function, contact a qualified service technician.
2, Wrong password:
menu password is entered incorrectly or the wrong password has been
used. Qualified service technicians, refer to "ADJUSTMENTS," in
HP 8360 B-Series Swept Signal Generator/HP 8360 L-Series
the
Swept CW Generator Service Guide
4, Unable to store data in EEROM
5, Not allowed to change address
6, Switch on Processor Board is Set:
a service adjustment menu password can not be set because the
This can only be caused by an internal
This can only be caused by an internal
This can only be caused by an internal
This error will only occur if the service
This error will only occur if the
This error occurs when the service
HP 8360 B-Series Swept Signal
The particular function invoked has
This error occurs when the service adjustment
for more information.
This error occurs when
for
Error Messages 2a-5