Amp1 Markers; Analyzer Status Register - HP 8360 L Series User Manual

Function Group
M e n u M a p 3
Description
Programming Codes
See Also
Function Group
Menu Map
Description
MARKER
Active markers are normally displayed as intensified dots on a CRT
display. With Amp1 Markers selected, active markers are displayed
as amplitude spikes (an abrupt discontinuity in the sweep trace).
The marker amplitude can be varied. The swept CW generator
displays:
represents an amplitude value. Use the rotary knob, the step keys,
or the numerical entry keys with the dB(m) terminator key to
set the desired value. If a small change is required, the left and
right arrow keys can be used to underline the digit to be changed.
Select Amp1 Markers again to return to the normal intensified dot
representation. See "Specifications" for the range of acceptable
amplitude values. An asterisk next to the key label indicates this
feature is active.
SCPI: MARKer:AOFF
Analyzer: AK1 function on, AK0 function off.
"Marker Operation" in Chapter 1
"Setting Up A Typical Sweep, Example Program 3" in Chapter 1
NONE
NONE
The following is the status register structure of the swept CW
generator when the analyzer programming language is selected. This
status structure is the structurally and syntactically the same as on
the HP 8340/41.
bytes from the swept CW generator. The first status byte
concerns the cause of an SRQ (Service Request), while the
second status byte concerns failures and faults, as follows:

ANALYZER STATUS REGISTER

Operating and Programming Reference A-13
where XXXX