HP 8360 L Series User Manual page 246

Power Slope
Function Group
Menu Map
Description
Programming Codes
See Also
POWER
5
This softkey lets you compensate for system, cable, and waveguide
variations due to changes in frequency, by linearly increasing or
decreasing power output as the frequency increases. RF slope values
may range from -2.50 to j-2.50 dB per GHz. The power at the
beginning of the sweep equals the current power level. An asterisk
next to the key label indicates that this feature is active.
POWer:SLOPe:STATe ONJOFFIllO
POWer:SLOPe <num>[DB]JMAXimum(MINimum~UP~DOWN
Analyzer:
functions in the fundamental units of dB/Hz, you program the SL
code SLmdt, where m is 1 (on) or 0 (off); d is the numerical value
in dB/Hz, and t is either "DB" or the ASCII LF terminator. For
example, for a slope of 1.5 dB/GHz use this procedure:
1. 1.5 dB/GHz = 1.5 dB/1,000,000,000 Hz
2. 1.5 dB/lES Hz = 1.5E-9 dB/Hz
3. The programming code is "SL11.5E-9 DB"
(
POWER
"Power Sweep and Power Slope Operation" in Chapter 1
Operating and Programming Reference P-7
Power Slope