HP 8360 L Series User Manual page 368

Z-Axis Blanking/Markers Output
Supplies positive rectangular pulse (Approximately +5 volts into
2 k0) during the retrace and bandswitch points of the RF output.
Also supplies a negative pulse (-5 volts) when the RF is at a marker
frequency (intensity markers only). (BNC female, rear panel.)
Supplies voltage proportional to output frequency at 0.5 volts/GHz
(internally switchable to 0.25 or 1 volt/GHz). Maximum output 18
volts. Minimum load impedance 2 kR. Accuracy k-0.5%, fl0 mV,
typical. (BNC female, rear panel.)
Source Module Interface
Provides bias, flatness correction, and leveling connections to
HP 83550-series millimeter-wave source modules (Special, front and
rear panels.)
Auxiliary Interface
Provides control signal connections to HP 8516A S-parameter Test
Set. (25-pin D-subminiature receptacle, rear panel.)
HP 83623L: 10 MHz to 20 GHz High Power
Models
H P 83630L: 10 MHz to 26.5 GHz
HP 83640L: 10 MHz to 40 GHz
HP 83650L:
Options
Option 001 Add Step Attenuator
With this option, minimum settable output power is -110 dBm.
Maximum leveled output power is lowered by 1.5 dB to 20 GHz, and
2 dB above 20 GHz, and 2.5 dB above 40 GHz.
Option 004 Rear Panel RF Output
Moves the RF Output, External ALC Input, Pulse Input/Output,
AM Input, and FM Input connectors to the rear panel.
Option 008 1 Hz Frequency Resolution
Provides frequency resolution of 1 Hz.
Option 700 MATE System Compatibility
Provides CIIL programming commands for MATE system
compatibility.
10 MHz to 50 GHz