HP 8360 L Series User Manual page 412

erase array entries, D-l
erase memory, C-2
erase undefined entry, D-3
erase user defined menu, U-5
erase user defined softkey, U-5
error messages, 2-1, 2a-1-8
error queue, clear, S-12
event commands, l-72
event detection trigger state
details of operation, 1-112
in general programming model, l-110
event register, l-107
in general status register model, l-106, l-107
events
event commands, l-72
example program
flatness correction, l-103
HP-IB check, l-90
local lockout, 1-91
looping and synchronization, l-99
setting up a sweep, l-93
synchronous sweep, l-101
use of queries, l-95
use of save/recall, l-97
example programs, l-87-105
examples, equipment used, l-2
examples, simple program messages, l-72
example, stimulus response program, l-77
extended numeric parameters
discussed in detail, l-84
explained briefly, l-74
extenders
HP-IB, C-7
trigger source defined, 1-119
external ALC BNC, L-3, L-4
external ALC connector, C-4
external detector calibration, E-5
external detector leveling, L-3
external frequency standard, T-l
external leveling, l-23-29
coupling factor, C- 11
detector calibration, E-5
low output, l-26
theory of, A-7
with detectors, couplers, or splitters, l-23-26
with power meters, l-27
with source modules, l-28
external power meter range, P-16
external trigger
frequency list, L-9
external trigger, stepped sweep, S-62
external trigger, sweep mode, S-55
Index-7