HP 8360 L Series User Manual page 289

S-32 Operating and Programming Reference
Queries and turns the frequency offset off and on.
After *RST, the setting is OFF.
l
l
Sets and queries the frequency span.
information.
l
l
Sets and queries the START Frequency.
information. *RST setting is MIN.
l
l
Sets and queries the function switch that controls the calculation of
the frequency step size
AUTO ON, then the swept CW generator selects a step size that is
coupled to the frequency span. The *RST setting is
l
suffix] IMAXimumlMINimum
l
Sets and queries the frequency step size to use for any node in the
frequency subsystem that allows
this value explicitly causes
The *RST setting is automatically calculated from span.
l
l
Sets and queries the stop Frequency.
information. *RST setting is
l
INITiate:CONTinuous?
l
Sets and queries the state of the continuous initiation switch. This is
more commonly known as single or continuous sweep. This does not
affect a sweep in progress. *RST setting is
l
Causes the initiation of a sweep. Useful mainly in the 1NIT:CONT OFF
mode of operation (single sweep). By combining the *OPC, *WA1
facilities with the 1NIT:IMM command, the functionality of the
See FREU : CENTER for more
See FREU : CENTER for more
UP and DOWN as
a
See FREQ : CENTER for more
MAX.
OFF.
ON.
parameters. Setting