Sweep Mode Ramp; Sweep Mode Step - HP 8360 L Series User Manual

Sweep Mode Ramp

Function Group
M e n u M a p 7
Description
Programming Codes
See Also

Sweep Mode Step

Function Group
M e n u M a p 7
Description
Programming Codes
See Also
S-66 Operating and Programming Reference
SWEEP
This softkey activates the analog frequency sweep mode. Ramp
sweep mode is the factory preset state. An asterisk next to the key
label indicates that this feature is active.
FREQuency:MODE SWEep
SWEep[:FREQ uency]:GENeration ANALog
Analyzer:
NONE
CONNECTORS,
"Programming Typical Measurements" in Chapter
SWEEP
This softkey activates the stepped frequency step mode. In this
mode, the swept CW generator steps from the start frequency to
the stop frequency, by the designated frequency step size. Manual,
continuous, and single sweeps can be performed in this mode. An
asterisk next to the key label indicates that this feature is active.
FREQuency:MODE SWEep
SWEep[:FREQ uency]:GENeration STEPped
Analyzer:
NONE
"Using Step Sweep" in Chapter 1
1